Dolby Conference Phone
Version 4.5
Configuration Guide for BT MeetMe with Dolby Voice
Introduction
About this documentation
New in this version
Related documentation
BT Conferencing
support
Documentation feedback
Configuration procedures
Prerequisite information
Plug and play setup
Plugging in and setting up the
phone
automatically
Configuring 802.1X
Opening the
phone
web interface
Configuring the operational mode
Configuring
(NTP)
Specifying a proxy server
Specifying
VLAN
and
LAN
settings
Firewall configuration requirements
Setting the
phone
display name
Activating a phone with a PIN
Updating credentials and certificates
Updating 802.1x authentication credentials
Uploading a new CA certificate
Deactivating the
BT MeetMe with Dolby Voice
service
Deactivating the service using the web interface
Deactivating the service using the diagnostic shell
Troubleshooting configuration issues
Making a diagnostic call
Error messages
BT MeetMe with Dolby Voice
conference call issues
Manually overriding DHCP assigned DNS settings
Glossary
Notices
Copyright
Trademarks
Patents
Search
Introduction
This documentation provides instructions for configuring your Dolby Conference Phone for BT MeetMe with Dolby Voice. It is compatible with the 4.5 version of the Dolby Conference Phone.
Configuration procedures
After you configure the Dolby Conference Phone network settings and options, you can activate the phone with BT MeetMe with Dolby Voice.
Updating credentials and certificates
You can update 802.1x credentials and upload device certificates without rebooting the Dolby Conference Phone.
Deactivating the
BT MeetMe with Dolby Voice
service
You can deactivate the BT MeetMe with Dolby Voice service by using either the diagnostic shell or the web interface. A factory reset does not delete the BT service certification authority (CA) certificate.
Troubleshooting configuration issues
There are several ways you can try to diagnose system issues before escalating to BT support. You can try making a diagnostic call, or troubleshoot an issue based on the error message.
Glossary
Notices